PiRLPでReflector9100にアクセス

/home/irlp/custom/environmentファイルでリフレクター接続時間制限値をデフォルトの20分（1200秒）に設定しているのに、５分～10分でdisconnectする場合があることに気付く。

原因が解らない(-_-;)　ログ見ても解らない・・・

インターネット回線の問題なのかな？

Reflector9100にコネクト

# su - repeater
repeater@stn8648:~/$ decode 9100
CODEC chosen as UNCOMP for channel 0.
Valid IP = 208.70.77.195 obtained from server
The reflector IP is determined to be 208.70.77.195
Trying 208.70.77.195, port 15425...
Connected to 208.70.77.195
Authentication Complete, registering IP address with reflector
Node Connected to reflector ref9100 on channel 0

environmentファイル

# This file is the IRLP ENVIRONMENT file. It is designed to set a list of
# global variables which are used by the software. Be careful when editing
# this file as a small error can make you node totally unusable.

# Place the callsign of your node below. USE ONLY LOWERCASE LETTERS
export CALLSIGN=jf9lgl

# Put the IRLP station ID of your node below. NOTE you must enter the correct
# stationid which is assigned to you. Any other ID will cause your node not to
# operate properly.
# USE ONLY LOWERCASE LETTERS
export STATIONID=stn8648

# Put the version of the Linux OS you are running below. This value is used to
# modify some scripts where syntax varies (e.g. sox). Possible values include:
# - CentOS
# - Debian
# - Slackware (for embedded IRLP nodes)
# - Ubuntu (not yet supported)
export LINUX_OS=Debian
---省略---
# This sets whether your node uses call waiting or not. By default it is
# set to YES. To turn off call waiting, comment out the following line
export CALL_WAITING=YES

# Sets the reflector timeout value in seconds.
# If you do not want the reflectors to timeout at all, just enter 0
export REFLECT_TIMEOUT_VALUE=1200
---省略---